Fluorescent whitening agent flash dryer XSG-6

Product drying requirements and process design:

1. Material Name: Fluorescent Whitening Agent

2. Initial moisture content of material: ≤ 25% (mass ratio)

3. Dry final moisture content: ≤ 0.1% (mass ratio)

4. Design output: 350-400kg/h (based on dry weight)

5. Inlet air temperature: 200-240 ℃.

6. Air outlet temperature: 110-120 ℃

7. Finished particle size: 300-400 mesh; Bulk density: 0.3g/cm3

8. Material yield: ≥ 99%

9. Heat source: Thermal oil.

10. Material: SUS304 is used for the parts that come into contact with hot air and materials

11. Inlet air requirement: initial effect

12. Dust removal method: cyclone+pulse bag

13. Control method: Adopting PLC control

14. Cyclone discharge adopts pneumatic double butterfly valve with 100L transition bin

15. Installation of pneumatic vibration hammer on cyclone separator and pulse dust collector

Fluorescent whitening agent flash dryer XSG-6feature：

The use of dual channel tangential air intake avoids the velocity non-uniformity of the rotating field in the radial flow field.

Effectively control the final moisture content and fineness by coordinating and unifying the swirl blades and inlet air velocity.

Rotating blade arrangement structurespecial，Characterized by low wear, wide contact surface, and high cutting force.

Skilled in handling heat sensitive materials, the bottom of the host belongs to the high-temperature zone, where the gas velocity is high and there is a cooling water protection device to avoid the possibility of material coking and discoloration.

Low system resistance, high thermal efficiency, good operating environment, and low labor intensity.

The host adopts a new sealing structure, which extends the service life of the host bearings and the bearing seat is equipped with a water isolation sleeve circulation cooling device.