Double cone rotary vacuum dryer is a type of double cone rotary tank that integrates mixing and vacuum drying. The tank of this dryer is in a vacuum state, which ensures that materials are quickly dried when entering the tank. This machine is suitable for vacuum drying and mixing of powder and granular materials in industries such as pharmaceuticals, food, and chemicals.
Operating procedures for double cone rotary vacuum dryer:
1. Pre driving inspection:
a、 Turn on the vacuum pump to check for leaks at the pipeline connections and packing boxes, good sealing at the inlet and outlet ports, and sensitive response of the vacuum gauge.
b、 Open the cooling water valve to check the connection of the heat transfer pipeline, whether the packing box leaks, and whether the pressure gauge responds sensitively.
c、 Check if all instruments, buttons, and indicator lights in the electrical control cabinet are functioning properly, verify if the grounding wire is in good condition, and if there is any leakage or short circuit.
d、 Fill each oil cup with lubricating grease, start the motor and run it empty, listen for the noise to see if it is normal. If it is not normal, check the source of the noise and eliminate it.
2. Add the dry material to the container (vacuum feeding is used for powdered, fine granular, and slurry materials), and then close the feeding hole cover.
3. After closing the vacuum valve, turn on the vacuum pump to create negative pressure (600-755 mmHg) inside the drying container.
4. Close the power switch, start the motor, press the work button, and the dryer starts rotating.
5. Open the valve of the heat carrier and allow it to enter the interlayer of the drying container for testing according to the process requirements.
6. After the material is dried, first close the heat transfer valve, and then inject cooling water into the interlayer. After the material cools to room temperature, stop vacuuming. Open the vacuum valve, turn off the motor, stop the dryer from rotating, and open the hole cover to discharge the material.