In industries such as pharmaceuticals and food processing,Swing GranulatorDue to its efficient granulation ability, it is highly favored, and the tightness of the screen clamp directly affects the uniformity of particles and the quality of the finished product. Precise adjustment is crucial.

Before adjustment, be sure to shut down and cut off the power supply to ensure safe operation. Firstly, observe the installation status of the screen mesh. Under normal circumstances, the screen mesh should be flat and tightly attached to the discharge port of the granulator, and evenly fixed around by the screen mesh clamp. If the sieve clamp is too loose, the material is prone to leak out from the gaps, leading to an increase in the proportion of small particles and even impurities, affecting the uniformity of particle size; If the mesh is too tight, it may deform, hinder the normal passage of particles, cause blockage, and damage the mesh due to friction and overheating, shortening its service life.

When adjusting, use specialized tools such as wrenches or screwdrivers. For bolt type screen clamp, find the fixing bolt and turn it clockwise to tighten the screen clamp. The amplitude of each twist should be small. While twisting, gently shake the screen by hand to feel the tightness change until the screen is stable and can shake slightly; Counter clockwise is the relaxation operation, and when excessive material leakage is found, it should be tightened appropriately. If it is a lever type screen clamp, by adjusting the nut at the end of the lever, lift the nut upwards to reduce pressure and loosen the screen, and downwards to increase pressure and tighten the screen, it is also necessary to test while adjusting.

During the adjustment process, it is necessary to consider the characteristics of the material. For materials with good fluidity, such as grain powder, the sieve clamp can be slightly loosened to facilitate rapid particle discharge; And for viscous materials, such as certain medicinal paste powders, tighten the mesh clamp appropriately to prevent adhesion and blockage. After completing the adjustment, start the machine for trial operation, feed a small amount of material, observe the particle discharge situation. If there are still problems, stop the machine again for fine adjustment, repeat several times until the screening effect reaches the ideal state, ensuring that the pellet machine produces uniform and qualified pellet products.

From safety preparation to material control, and then to trial machine optimization, the adjustment of the mesh clamp of the swing pellet machine needs to be rigorous and meticulous. Only in this way can the pellet machine operate efficiently and stably, safeguarding production.