Conditions for installing a step in (water-cooled) water tower:

Our water and electricity need to be supplied to the rear of the unit.

1Cooling water pipe:50pipe(2Inch).

That is to say, when the cooling water enters and exits, (for installing a water tower: there are two back and forth connections between the water tower and the equipment)50Tube, one2.5Square three core cable).

2: Three phase5Line system,16Square line, supplied to the wall behind the unit.

3The drainage pipe shall not be lower than25Pipe, connected to the rear of the unit for easy drainage.

4If convenient, it is recommended to pull a pure water pipe to the back of the equipment, so that there is no need to manually add water in the later stage.

There must be a self-contained water source near the equipment for connecting and ensuring long-term supply during the installation of the laboratory (with a water pipe diameter of 4 minutes),One 4-point ball valve is attached. The water tower is installed outdoors, and through the circulation and fluidity of water, it can quickly remove heat, ensuring that the equipment isStable operation under temperature and humidity conditions. The water cooling system can smoothly absorb the heat generated by the equipment by continuously circulating cooling water, avoidingThe temperature fluctuation caused by the start and stop of the fan in the air-cooled system improves the repeatability and reliability of the test data. By optimizing the heat dissipation performance,It can reduce overall system energy consumption and lower long-term operating costs. It only consumes two or three kilowatt hours of electricity per hour.The maintenance focus of the water cooling system is on water quality management (such as regular descaling). Although the heat dissipation effect is good, it is necessary to regularly clean the packing to preventStop algae growth, lower cost.