The traditional Chinese medicine decoction piece packaging machine can be applied to the combination packaging of various traditional Chinese medicine decoction pieces, including functional foods, capsules, pills, etc., to form diversified drug combination products. In addition, it can also be used to package small doses of traditional Chinese medicine decoction pieces, especially suitable for automatic weighing, sealing, and packaging of irregularly shaped tablets, rhizomes, seeds, and other products. ‌

The common faults and solutions of traditional Chinese medicine decoction piece packaging machines include the following:

1. The preset measurement is inconsistent with the actual packaging measurement:

Reason for malfunction: Blockage in the infusion line resulted in a slower liquid injection rate, and the actual infusion volume was less than expected.

Solution: Remove foreign objects attached to pipelines and solenoid valves to ensure smooth liquid injection.

2. Side leakage when medication is poured into the bag:

Reason for malfunction: There is a problem with the side sealing of the packaging bag or the liquid injection speed is too fast.

Solution: Fine tune the control switch or check if the heating temperature of the sealed tube is abnormal.

3. Continuous leakage in the infusion tube:

Reason for malfunction: There are foreign objects on the sealing ring of the solenoid valve that affect the sealing effect.

Solution: Clean the foreign objects on the sealing ring of the solenoid valve.

4. Adhesive adhesion during packaging bag cutting:

Reason for malfunction: The cutting wheelbase is set too large.

Solution: Fine tune the cutting wheelbase.

5. Leakage or failure to dispense medication at the injection port:

Solution: Clean the solenoid valve, outlet valve, and outlet pipeline inside the packaging chassis.

6. Excessive overflow of medication in the bag:

Reason for malfunction: The liquid level probe is not functioning.

Solution: Check the wiring and circuit board of the probe circuit.

7. Misalignment of left and right adhesive in packaging:

Solution: Check if the roll is installed correctly, adjust the packaging film guide ring, and clean the dirt on the upper roller.

8. During the packaging process, there is a phenomenon of bag pulling:

Solution: Adjust the position of the cam and micro switch again.

9. The packaging bag is too bulky and the seal is not smooth:

Solution: Adjust the squeezing piece on the secondary blade shaft downwards appropriately.

10. Continuous cutting of packaging bags:

Solution: After loosening the fixing screw of the main blade, adjust the left, right, or middle screw according to the specific situation.