Huizhou multi-function agarwood ass hide glue stainless steel grinder

Huizhou multi-function agarwood ass hide glue stainless steel grinder

working principle

The high-energy crusher uses a turbine disk to drive movable blades to impact and shear materials, as well as alternate between material and material, material and ring gear impacts and friction for crushing. The roulette wheel is equipped with a fan blade device, which can generate strong wind force during operation, play a negative pressure feeding function, and take away a large amount of heat from the cavity. It can also timely supplement the external air, greatly improving production efficiency and output.

Machine features:

1. The structure is simple, the crushing chamber is easy to assemble and disassemble, and easy to clean.

2. This machine is made of all stainless steel and meets GMP requirements.

3. Smooth operation, low noise, and minimal vibration.

4. Easy to operate. Replacing the sieve can control the fineness of the powder.

Huizhou multi-function agarwood ass hide glue stainless steel grinder

Instructions and precautions for use:

1. This machine is usually packaged in 2 wooden frames. After the customer receives the goods, the wooden frames are opened and the main unit is placed on a horizontal ground. Rubber pads can be placed on the machine feet.

2. Before starting the machine, carefully check whether the wires are complete, whether the power cord is exposed, whether the machine components are tight and firm, whether the lubricating oil in the oil cup is sufficient, lock the door cover outside the crushing chamber, then connect the main power supply, press the switch, run the machine empty for more than ten minutes without any abnormal sound or vibration, and then start feeding work. If abnormal noise is found during startup, the switch should be immediately turned off and the main power should be turned off. After identifying and resolving the problem, the machine can be restarted.

3. Different models have varying production volumes. The smaller the machine, the lower the output. No matter how large the model is, there are also production specifications. Pay attention to controlling the feeding amount. In principle, the machine should output a certain amount of powder per minute, and the feeding amount should not exceed the powder output. Too much input, too little powder output. The machine has too much material in the crushing chamber, causing excessive motor load. If the motor speed slows down or even stops running, the machine switch should be turned off immediately and the main power should be cut off. Then, the machine cover should be opened to clean the material in the crushing chamber, and the door cover should be locked before restarting.