Disinfection method and flushing of syrup filling machine
1. Align the upper and lower circular holes of the 500ml stainless steel filling system with the upper and lower fixing rods respectively, fit them onto the bearings, and make them
The outer end face is level with the bearing surface, tighten the two set screws.
2. Look at the ruler, measure the pointer, then tighten the fixing rod and tighten the nut.
3. The syrup filling machine uses a short rubber hose to connect the water outlet nozzle and valve connection nozzle of the filling system
Connect the liquid pipeline to the water inlet and remove the rust
Connect the steel sinker head to the liquid pipe and place the other end into the liquid to be filled. Connect the outlet pipe to the water outlet to prevent
Stop the entanglement of the liquid outlet pipe and connect it to the outlet pipeInsert it into the side ear opening of the chassis.
4. Turn on the main power switch and adjust the speed controller knob to achieve the desired filling speed
Install speed. Note: Large capacity fillingThe speed should be slower, and it can be adjusted faster when the capacity is small.