The HPJ series polishing machine mainly consists of a hopper, polishing cylinder, sealing cylinder, brush, coupling, split bearing seat, motor, distribution box, waste removal head, discharge hopper, and frame.
Here are the general steps for using a drug polishing machine. as follows:
1. Connect one of the suction tubes of the industrial vacuum cleaner below the polished sealing cylinder; Connect another suction tube of the industrial vacuum cleaner above the waste collector.
2. Connect the power supply of the industrial vacuum cleaner and polishing machine, and adjust the speed of the polishing machine. Test the machine with a small amount of waste shell capsules and adjust the negative pressure air intake of the waste remover to just remove the empty shell fragments. If the negative pressure intake is too high, it may remove the good capsules, while if it is too small, it cannot have a waste removal effect. The exhaust air volume is adjusted on the regulating plate at the inlet of the industrial vacuum cleaner, and the exhaust situation can be observed from the observation plate in front of the exhaust cleaner. The air volume of the suction tube for removing medicinal powder is also adjusted on the industrial vacuum cleaner control panel.
3. After completing the above preparations, work can proceed.
4. Clean the polishing machine and industrial vacuum cleaner promptly after each shift is completed. When necessary, industrial vacuum cleaners should also be cleaned during work.
During use, adjustments can be made based on these aspects:
(1) Polishing machine speed regulation: organized by an electronic speed controller. For fragile capsules, the rotational speed can be appropriately low, otherwise it can be adjusted appropriately high. When used for polishing tablets, the rotational speed can be appropriately reduced.
(2) Tilt adjustment of polishing cylinder: The tilt angle is adjusted by the tail support plate. A large tilt angle has good polishing effect, while a small tilt angle has high production efficiency.
(3) Industrial vacuum cleaner adjustment: Professional industrial vacuum cleaners have two sets of dust cleaning tube devices, each with a suction air volume adjustment plate, and the air volume is adjusted according to the usage situation.
Through the above introduction to the use of the drug polishing machine, we hope it will be helpful for everyone to understand the drug polishing machine.