The swing pellet machine develops wet powder or block shaped dry materials into the required pellets, and its screen adopts metal wire mesh, which is easy to install and disassemble, and the tightness can be adjusted. The main mechanical components are enclosed within the machine body and equipped with a lubrication system, ensuring smooth operation during the production process. The overall appearance of the machine is made of stainless steel plates. Compliant with GMP standards, significantly improving the quality and economic efficiency of particles. This machine is widely used in industries such as pharmaceuticals, food, and chemicals.
What is the main structure of a swing pellet machine?
main body
The body is an independent rectangular cylinder, with a closed bearing seat connected to the powder hopper. The powder hopper extends outward from the body of the machine, and a V-shaped chassis is installed below it, which is wide and flat on the ground, so it needs to be installed below and can be placed indoors for use at will.
Screen clamp tube
The device is made of steel pipes on both sides of the rotating drum, with a long groove in the middle. The two ends of the screen mesh are embedded in the groove, and the flower shaped handwheel is rotated to wrap the screen mesh around the outer circle of the rotating drum. The handwheel is supported by gears, and the tightness can be adjusted.
Motor frame
Once the screw is securely fastened, the motor is mounted on the iron plate. When the screw bolt is rotated, the motor moves up and down to adjust the belt.
gearbox
Adopting worm gear transmission, the oil can be stored in the box to ensure good lubrication and no noise of the gears. There is a sight glass on the box for observation of the operation and oil storage. The outer end of the worm gear is equipped with an eccentric shaft, which drives the rack to move back and forth.
Particle manufacturing equipment
The rotating drum is horizontally placed under the powder hopper, with bearing supports at the front and rear. It rotates in a reverse direction through the transmission of gears. The front bearing cover on the end face is movable. When assembling and disassembling, simply unscrew one wing nut, and the bearing cover and rotating drum can be removed. The two ends of the drum are made with convex square rings and embedded in the bearing chamber, which can prevent oil stains from infiltrating the powder and sticking and blocking.