13D motion mixerPurpose and Features

This machine is used for high uniformity mixing of powdered and granular materials in pharmaceutical, chemical, food, light industry, electronics, machinery, mining and metallurgy, national defense industry, and various scientific research units. The mixing cylinder of this machine moves in multiple directions, with no centrifugal force acting on the material, no specific gravity segregation or layering, and no accumulation phenomenon. Each component can have different weight ratios, and the mixing rate can reach99.9%above,It is currently an ideal product among various mixers.

II3D motion mixerMain technical parameters

Three,3D motion mixerworking principle

Under the driving force of the active shaft, the loaded cylinder undergoes a compound motion of cyclic translation, rotation, and rolling, which promotes the material to undergo a three-dimensional compound motion along the cylinder in the circumferential, radial, and axial directions, thereby achieving the mutual flow, diffusion, accumulation, and doping of various materials to achieve uniform mixing.

III3D motion mixerinstall

This machine only needs to be placed on a sturdy and flat ground (with an unevenness of ≤3/1000）Just enough.

The power of this machine is2.2Kilowatts, the total incoming line consists of three phase lines and one neutral line to the equipment.

Mark the largest workspace of the mixer,To avoid injuring staff during work.

43D motion mixeroperation

1. Check if the power supply meets the requirements.

2. Check if all electrical appliances and instruments on this machine are functioning properly and in good condition.

3. Run empty first,Check if the steering of the drive shaft is consistent with the markings.

4. According to the prescribed loading amount, mix the materials

53D motion mixerPrecautions：

1. The casing of this device must have a good grounding.

2. The material barrel and rocker arm parts need to be moved in three-dimensional space, so users must set up protective railings or clear warning lines within the rotation range of the equipment to prevent personal accidents.

73D motion mixerMaintenance and Care

1Lubricating oil and grease should be regularly injected into the gearbox and bearings.

2Regularly check the operation of each transmission part and the looseness of each fastener part.