Swing granulator is a device that develops wet powder or block shaped dry materials into the required particles. It mainly uses a mixture of wet powder to forcibly pass through a sieve under the positive and negative rotation of a rotating drum to produce particles.

Of course, when we use the swing granulator in our daily lives, we inevitably encounter some problems, and many of these problems may be caused by improper maintenance. Therefore, here I will explain some methods for daily maintenance of the swing granulator:

1. Regularly inspect the machine parts, once a month, to check whether the moving parts such as the worm gear, worm gear, bolts on the lubrication block, bearings, etc. are rotating flexibly and worn. If any defects are found, they should be repaired in a timely manner and not forced to be used.

2. The machine should be used indoors in a dry and clean environment, and should not be used in places where acids or other corrosive gases are circulating in the atmosphere.

3. After the machine is used up or stopped, the rotating drum should be removed for cleaning and brushing the remaining powder in the bucket, and then installed properly to prepare for the next use.

4. When the drum moves back and forth during operation, please adjust the M10 screw on the front bearing to the appropriate position. If the gear shaft moves, please adjust the M10 screws behind the bearing frame to the appropriate position, adjust the clearance so that the bearing does not make any noise, manually rotate the pulley, and tighten it appropriately. Over tightening or over loosening may cause damage to the machine.

5. If the machine is not in use for a long time, it must be wiped clean all over the body, and the smooth surface of the parts should be coated with anti rust oil and covered with a cloth.

In fact, the maintenance and use of machinery is one aspect. All machinery needs lubrication. The following is how to lubricate equipment. It is not only suitable for swing pellet machines, but also for low-temperature vacuum dryers. Therefore, everyone should take a closer look.

1. The box of the machine is equipped with an oil gauge. Before driving, all the oil should be added once, and it can be added midway according to the temperature rise and operation of each bearing.

2. The worm gear housing must store engine oil for a long time, with the oil level reaching the point where the worm gear is completely immersed in the oil. If used frequently, the oil must be replaced every three months, and there is an oil plug at the bottom that can be used to drain the oil.

3. When refueling the machine, do not let the oil overflow beyond the cup, and do not let it flow around the machine or onto the ground, as oil can easily contaminate materials and affect product quality.