The dual color rotary tablet press is an automatic rotating continuous tablet press machine widely used in the pharmaceutical industry, as well as in industries such as food, chemical, and electronics. Press various granular raw materials that meet the compression requirements into tablets. It can also suppress irregular shaped pieces and double-sided engraved pieces.

The maintenance and upkeep of the dual color rotary tablet press mainly include the following aspects:

1. Daily maintenance and upkeep:

Clean the hygiene of the tablet press room: Regularly clean the tablet press room to avoid the accumulation of small powder materials, and prevent problems such as clogging and poor rotation.

Check the position of the lubricating oil level: Check the position of the lubricating oil level every day when taking over the shift to ensure sufficient lubricating oil and avoid equipment damage due to insufficient lubrication.

Manual addition of lubricating grease: Use a manual pump to add lubricating grease once per shift to ensure the flexible operation of all moving parts of the equipment.

Clean the dust collection compartment of the vacuum cleaner: Regularly clean the dust collection compartment and motor compartment of the vacuum cleaner to keep the interior of the equipment clean.

Check the gap between the feeder: Ensure that the gap between the feeder and the worktable of the punching plate is 0.05mm during each loading and unloading of the feeder.

Check the dust ring and adjust the downward damping: Every time you disassemble the upper and lower punch, check the dust ring and adjust the downward damping to ensure the normal operation of the equipment.

2. Regular inspection and maintenance:

Check the coaxiality of the punch hole and the middle mold hole: Regularly check the coaxiality of the punch hole and the middle mold hole, and if necessary, repair or replace severely worn components with a reamer.

Tighten the turntable and guide rail components: Regularly tighten the turntable and guide rail components to prevent equipment failure caused by looseness.

Replace worn parts: Regularly inspect and replace worn guide rails, pressure wheels, and other components to ensure the normal operation of all parts of the equipment.

• Flaw detection test and appearance inspection: Before use, conduct strict flaw detection test and appearance inspection on the die to ensure that it is free of defects such as cracks, deformation, and missing edges.