1. Immersion medicine

a、 Prepare 1-2 soaking containers, usually using plastic buckets.

b、 Wash the cloth bag and put the Chinese medicine to be fried into it. Generally, it should not exceed fifteen patches (depending on the amount of medicine). Then tie the bag tightly with smooth cotton thread or hemp rope.

c、 Prescription soaking: The soaking time is about 30 minutes, and the water absorption of traditional Chinese medicine is about 1.5-2 times the weight of the medicine. The amount of water added should be based on the amount of water that has flooded the medicine bag.

d、 Pay attention to placing the prescription form on the soaking container bucket to prevent confusion and mistakes.

2. Decoction:

a、 Check if the filling valve and backup valve are closed.

b、 Estimate the amount of water for decoction: First, pour the water used to soak the Chinese medicine into the medicine pot. Place the soaked Chinese medicine in a filter and add about 400 milliliters of water for each dose of medicine, depending on the amount of medicine. The evaporation rate during the frying process is about 100-150 milliliters per serving (paste) of water, and after determining the amount of water (calculated based on the number of traditional Chinese medicine paste). Then put the soaked traditional Chinese medicine and filter into the decoction pot. Strictly prevent traditional Chinese medicine from falling into the pot and causing blockage during packaging.

c、 Turn on the main power switch of the decoction pot.

d、 Press the "Heat" button to set the required cooking time for both high and low heat, and then return to the high heat state to start frying the medicine. (The firepower in Wuhuo is greater than that in Wenhuo)

e、 Gum medicines such as ass hide glue should not be directly boiled in a medicine pot. Instead, they should be dissolved in another container. After the Chinese medicine is cooked, they should be added to the medicine pot. After mixing well, they should be packaged together with the liquid medicine.

3. Packaging:

a、 20-30 minutes before starting packaging, turn on the "hot close" button and set the upper temperature to 160 ℃ and the lower temperature to 170 ℃. After setting, the green light will automatically close in and the setting indicator will automatically jump until it is balanced. Then, start packaging.

b、 After boiling the medicine, lift the filter in the medicine pot and place it diagonally at the top of the pot. Use the pressure plate of the extruder to squeeze the medicine residue in the bag, so that the medicine is drained completely.

c、 Set packaging quantity: The packaging quantity is determined based on the quantity on the decoction pot table after the medicine is decocted. Generally, one set (sticker) is two packages.

d、 Open the filling valve and press the "injection" and "start" buttons to automatically complete the packaging.

e、 It is advisable to manually pack the appropriate amount by using the "start" button to cut off and immediately turn off the package when it is full. After the medicine is filled, turn on the "start" button and continue to operate in order to achieve the amount packaging.

4. Cleaning:

a、 Clean the decoction pot, add water to the pot, and use a soft cloth to scrub the pot wall (do not use steel wool to scrub to avoid electromagnetic valve blockage). Then open the filling main valve and backup valve of the medicine pot to discharge the sewage inside the pot. After flushing, immediately close the filling main valve and backup valve.

b、 Cleaning the filling main switch pipeline: Add an appropriate amount of water to the decoction pot, use scissors to cut open the bag seal at the bottom of the machine head, turn on the filling main switch, press the "injection button" to discharge the sewage and medicine, and then turn off the filling main switch.

c、 Clean the cloth bag, check for any remaining residue, and promptly sew or replace the bag if it is damaged.