The strong coarse crusher mainly consists of feeding port, discharging port, inclined rolling cutter, punching mesh, motor and other components. The material is cut into small pieces by a high-speed rotating rolling cutter from the feeding port, sorted by a sieve, and the large particles continue to be cut until they pass through the sieve. The rolling cutter has a multi blade structure, high-strength bolt connection, and is easy to maintain. This equipment is widely used in various industries such as pharmaceuticals, chemicals, metallurgy, food, and construction. Processing hard and difficult to crush materials, including plastic, copper, rubber products, etc. It can also be used as a supporting equipment for micro crushers and fine crushers before processing.

Maintenance regulations and usage precautions for strong coarse crushers:

Maintenance Regulations

1. Daily maintenance:

♦ Daily maintenance is an important measure to extend the service life of machines.

♦ Regularly check the installation of component joints and tighten them if necessary:

♦ Replace severely worn and vulnerable parts;

♦ Regularly clean the interior of the machine to remove accumulated dust;

♦ Ensure that the power cord is connected properly:

♦ After long-term shutdown, the machine should be tested regularly to ensure normal operation.

2. Regular maintenance

♦ In addition to daily maintenance, regular maintenance at regular intervals can better protect the machine

♦ Regularly check the lubrication condition of the bearings and add oil;

♦ Regularly clean the filter element and sealing ring inside the machine to ensure its sealing performance;

♦ Regularly check for wire transmission faults and replace damaged wires.

Precautions for use

♦ The machine needs regular maintenance and upkeep, and timely replacement of vulnerable parts;

♦ Do not unplug the power cord before the machine stops running;

♦ When operating the machine, protective measures such as wearing gloves, masks, etc. are required;

♦ During machine operation, do not insert your hands into the interior of the machine or near the feeding port.