Hammer crushing equipment is particularly suitable for crushing hard, crystalline, and fibrous materials. The high-speed configuration can meet the required particle size and processing capacity of materials, and achieve the exchange of hammer crushing and knife crushing. The bearing adopts an air seal, which can effectively reduce friction and lower the temperature during operation. For special materials, a water-cooled cooling system can be equipped for easy maintenance.

Instructions for using hammer crusher

1. Cleaning work: Clean the equipment before use, remove any residue, and keep the operating environment clean.

2. Check the equipment: Check whether the vulnerable parts such as the hammer head, sieve plate, and hammer plate are intact, and replace them in a timely manner if they are damaged.

3. Power on preparation: Remove the internal materials of the crusher and check whether the oil and electrical circuits are unobstructed and firm.

4. Feeding operation: Feed materials according to the specified feeding amount and feeding port size, avoiding feeding too large or too small.

5. Processing operation: Pay attention to the quality and size of materials during operation, and stop the machine for inspection in a timely manner if there are any abnormalities,

6. Shutdown and parking: Before stopping the machine, handle the materials, do a good job of cleaning, and disconnect the power supply.

Maintenance and upkeep of hammer crusher

1. Lubrication: Bearings bear all the load of the machine, and good lubrication is crucial for bearing life. Regularly inject clean lubricating oil and check the sealing condition.

2. Check for looseness: Newly installed wheels and other components are prone to looseness and need to be checked and tightened regularly.

3. Replace vulnerable parts: Regularly check the degree of wear of vulnerable parts and replace severely worn components in a timely manner.

4. Cleaning the chassis: Keep the flat surface of the movable device chassis clean to prevent serious accidents.

5. Check the oil temperature: If the bearing oil temperature rises, stop the vehicle immediately to investigate the cause and eliminate it.

6. Check for noise: If there is any impact sound during the operation of the rotating gear, it should be stopped immediately for inspection and eliminated,