Cylindrical dust collectorThe working principle of
When the dusty gas enters the box from the bottom of the box, the finer dust is trapped in the cylinder by the filter. The purified gas passes through the filter and enters the upper box through the exhaust outlet. As the dust on the surface of the filter continues to increase during the filtration process, the resistance of the dust collector will also increase. In order to maintain the equipment within the limited resistance range, dust cleaning must be carried out to shake off the dust and reduce resistance. This series of products uses a pulse blowing method controlled by a controller to clean the dust. When the solenoid valve is powered on, compressed air is sprayed out through the blowing pipe to blow out the filter, causing each filter to instantly swell under the action of the blowing and induced gas source, shaking off the dust and discharging it through the ash discharge mechanism.
Cylindrical dust collectorThe main characteristics of
1. Small footprint, low noise, compact structural design;
2. Pulse control adopts a pulse controller with a simple circuit, adjustable injection interval and pulse width, monitored output, good stability performance, and high reliability
3. Cylindrical stainless steel box with good rigidity and strength;
4. This series of equipment is equipped with a pulse dust cleaning system to handle large air volumes;
5. Easy installation, debugging, and maintenance.