If the sulfur dioxide salt spray corrosion test chamber is not maintained like a person staying still, it is definitely unhealthySulfur dioxide salt spray corrosion test chamberHow to do a good job of maintenance during use:
Daily maintenance of sulfur dioxide salt spray corrosion test chamber:
1. After each experiment, the oil-water filter switch should be turned on to drain the accumulated oil and water.
2. If the salt water spray test chamber is not used for a long time, the water in the saturator should be drained, and the water storage in the saturator should also be replaced regularly during normal use.
3. Regularly check whether the air conditioning valve is functioning properly.
4. When the brine spray test chamber is not used for a long time, restart it for test, and check all electrical systems.
5. After the experiment is completed, the box should be cleaned and kept in a dry environment as much as possible.
6. If the electrical components on the control panel need to be replaced due to malfunction, do not disassemble them by yourself to ensure the service life of the test box.
7. In case of nozzle blockage, remove the nozzle, clean it with alcohol, xylene or 1:1 hydrochloric acid, or dredge it with ultra-fine steel wire, but do not damage the surface finish of the inner cavity of the nozzle, so as not to affect the quality of spray.
The above is about the daily maintenance of the sulfur dioxide salt spray corrosion test chamber, hoping to provide assistance to everyone.