1. After a long period of disuse, if it is necessary to use it again, the water source, power supply, and various components must be carefully checked to ensure that they are correct before starting the equipment.

2. During the experimental phase, the time for opening the box door should be minimized as much as possible.

3. The sensing devices in the studio should not be subjected to strong impacts.

4. During the operation of the equipment, it is essential to maintain sufficient water supply.

5. Non dedicated operators are not allowed to operate the UV aging test chamber at will.

6. When the device encounters a malfunction that cannot be resolved by itself, please contact our company.

7. Due to the strong harm of ultraviolet radiation to personnel (especially eyes), operators should try to minimize exposure to ultraviolet radiation (exposure time should be less than 1 minute). It is recommended that operators wear protective goggles and sheaths.

　　

Maintenance and upkeep of the wet heat aging test chamber for photovoltaic components:

In order to make the equipment work better and maintain good condition for a long time, regular maintenance and upkeep should be carried out:

1. When the equipment is not in operation, it should be kept dry, the running water should be drained, and the workshop and box should be wiped dry.

2. After use, cover the plastic casing to prevent dust from entering. If there is dust, it should be removed.