Instructions for using liquid filling machine:

1. Before the machine starts working, the ground wire must be properly grounded, and then the appropriate standard injector should be selected according to the different packaging quantities. When the general packaging range is 0.2-1ml, a 1ml syringe is used; Use a 5ml syringe for 1-5ml; When 5-10ml, use a 10ml syringe; 20ml model, using a 20ml glass infuser; The 100ml model uses a 100ml glass infuser, while the 500ml model uses our factory's stainless steel filling system.

2. Pull out the inner core of the syringe and insert the screw sleeve onto the inner core of the syringe (note: for 10ml models, due to the large difference in syringe diameter, gaskets need to be selected according to the size of the outer circle), and use the screw sleeve to properly fasten it to the lower base (cleaning must be paid attention to when disassembling and assembling the syringe).

3. Place the upper clamp seat on the outlet end of the syringe sleeve, and tighten the nuts on both sides appropriately (when using a 5ml syringe, tighten the sleeve together, being careful not to tighten too tightly, as the outer sleeve is fragile). Note: The 10ml model comes with an adjustment sleeve, while the 20, 100, and 500 models do not.

4. Assemble the assembled syringe core and outer sleeve into one unit, and the injection system is now fully assembled.

5. Fix the valve with the arrow facing upwards and the arrow mark facing outwards onto the fixing screw with a nut.

6. Assemble the complete injection system, align the upper and lower circular holes of the injection system components with the upper and lower fixing rods, fit them on the bearings, and make their outer end faces flat with the bearing surface. When assembling the lower end, do not let the screw sleeve and the crankshaft collide to prevent abnormal noise when the upper crankshaft rotates (when correctly installed, the distance between the screw sleeve and the crankshaft is about 1mm). After the injection system is correctly installed, tighten the upper and lower fastening screws. Connect the syringe and valve connection nozzle with a short rubber hose. The inlet pipeline is connected to the inlet, and the outlet pipeline is connected to the outlet. To prevent entanglement of the inlet and outlet pipes, clamp them into the side ear of the casing.

7. When manually turning the crank, it should be able to rotate freely. Otherwise, if there is an assembly error, check whether the injection system is fastened to the rotating bearing.