Vertical multi stamping machineUsed to press various granular raw materials into sheets, in addition to round sheets, it can also press various geometric shaped irregular sheets and double-sided engraved sheets. Its structure is double pressure, with two sets of feeding devices and two sets of pressure wheels. 25 sets of movable punch rods can be installed on the turntable, and 50 pieces can be pressed by rotating it once. When pressing circular discs, this machine can be equipped with double punch, triple punch, and quadruple punch according to the size of the disc diameter and the punch rod, making it suitable for mass production. The speed of the turntable, the filling depth of the material, the thickness of the tablet, and the height of the downward punch can all be adjusted during tablet pressing. Randomly attach a separate powder suction box, which can absorb the dust generated during machine operation through the powder suction tube and nozzle, avoiding dust adhesion and blockage, and can recycle raw materials for reuse.
Maintenance instructions for vertical multi stamping machine:
1. After a single use or shutdown, the remaining powder should be removed and the residual powder in the machine name section should be cleaned. If the machine has been out of use for a long time, the punching die must be completely removed and the machine must be wiped clean. The smooth surface of the machine should be coated with anti rust oil and covered with a cloth canopy.
2. The place of use should be regularly cleaned, especially for pharmaceutical and edible tablet manufacturing, where there should be no dust or flying dust present.
3. Regularly inspect the mechanical components, 1-2 times a month, to check whether the moving parts such as worm gear, worm gear, bearings, pressure wheel, crankshaft, upper and lower guide rails are rotating flexibly and worn. If any defects are found, they should be repaired and used in a timely manner.
4. The maintenance of the stamping die should be placed in a covered iron box, so that the stamping die is fully immersed in oil and kept clean to prevent rust and damage. It is best to customize the iron box to fit each specification in one box, which can avoid installation errors during use and help to grasp the damage situation.