Installation, commissioning, and maintenance of laboratory emulsifier:
1. Connect the power supply, ensure the power supply matches, and ensure that the ground wire is reliably grounded. Turn on the main power switch, and the power indicator light will turn on.
2. Connect all pipelines of the homogenization pot (including steam pipelines, overflow outlets, discharge outlets, and sewage outlets) and the inlet pipe (directly connected to tap water at the inlet), to be provided by the user.
3. Homogeneous cutting and scraper stirring, first add material (water can be used as a substitute), then turn on the corresponding control switches for homogeneous cutting and scraper stirring speed. The rotation of the homogenizer cutting wheel is reversed when facing the cutting wheel; the rotation of the homogenizer mixing wheel is reversed when facing the mixing wheel (looking down and up). During debugging, the homogenizer should be run by tapping and testing, and only after confirming that there are no errors can it be officially put into operation. Before starting the mixing process, it is also necessary to jog and check if there are any abnormalities in the mixing scraper wall. If there are any, they should be eliminated immediately.
4. To open the pot lid and material port lid, it is necessary to do so when there is no vacuum pressure inside the pot. If there is vacuum pressure inside the pot, the vacuum extraction interface should be closed, the valve on the lid should be turned off (and the vacuum pump should be turned off), and the valve on the pot lid should be opened to eliminate vacuum pressure inside the pot.
5. Regularly check the lubricating oil and grease in each component and bearing, and replace them with clean lubricating oil and grease in a timely manner.
6. Keep the homogenizer clean. Clean the parts of the homogenizer that come into contact with the working fluid, especially the cutting wheel cutting sleeve at the head, the sliding bearings inside the homogenizer shaft sleeve, and the shaft sleeve, every time the material needs to be stopped or replaced. After cleaning and reassembling, there should be no jamming phenomenon when turning the impeller by hand. After fixing the flanges of the pot body and lid relative to each other, the motor of the jog homogenizer should turn correctly without any other abnormalities before starting to operate.
7. All cleaning work for pots is handled by users according to standards.