The fully automatic water pill machine is a product of our factory, mainly used for the production of various specifications of traditional Chinese medicine pills in China. This device is not only suitable for the production of small and large honey pills, but also for making pills from materials with poor viscosity such as Tibetan pills, Mongolian medicine pills, and water pills; This machine has a small size, low noise, high production efficiency, wide applicability, easy operation and maintenance, and is an important new generation pellet making equipment.

Its working principle is to feed the mixed and uniformly refined medicinal paste into the hopper of the pill making machine, and through the flipping and extrusion of the flipping plate, the medicinal strips are extruded from the two side nozzles under the action of the thruster. When the medicine strip reaches a certain length, it is cut by an automatic cutter and then fed into the roller by the distributor at a speed of once per second. The position of the roller cutter and the tension of the conveyor belt can be adjusted separately through a fine-tuning device. Changing the size and weight of the pellets can be achieved by replacing the corresponding specifications of the pellet cutter roller, making the operation convenient.

Below are some precautions for using the device

1. This machine is suitable for indoor environments with ambient temperatures ranging from -5 ℃ to+40 ℃, relative humidity less than 90%, voltage fluctuations in the power grid less than 10% of the rated value, and no conductive dust or corrosive metal gases in the surrounding area. Installed in a sunny and clean factory building, there is no need for a foot, just level it. For safety reasons, a grounding wire is necessary.

2. Before driving, it is necessary to check whether the oil level of the gearbox has reached the standard position; Check if the oil cup on the hopper is filled with cooking oil; Check if the pill making machine is aligned and tightened; Check if the liquor cleaning system is unobstructed and adjust the appropriate amount. Disinfect the guide wheel, guide frame, pellet making knife, etc. with alcohol. Turn on the electric heating.

3. The delivery part will be air freighted for 3-5 minutes, and if there are no abnormalities, the material can be fed. Break the discharge strip, return a portion of it to the hopper, and wait for the strip to pass before opening the pellet making section. The feeding should be uniform during operation. If it is found that the dispensing and pill making are not synchronized, they can be adjusted by turning the knob. Clockwise pill making is faster, while counterclockwise pill making is slower. The size of the pill diameter can be achieved by replacing different dispensing ports, pill making knives, and guide wheels.

4. When feeding, foreign objects should not be thrown into the hopper, and hands should not be inserted into the flat surface of the hopper to avoid being crushed by the pressure plate. Regularly check for any abnormalities in various components, and immediately stop and inspect if any abnormalities are found.

5. After use, power off and turn off the main switch and other switches. Remove the strip outlet and electric heating cover before cleaning. When disassembling the machine head, a hook wrench can be used, and then the bracket and propeller can be pulled out. Open the upper part of the hopper and clean the two flip plate shafts. After cleaning, apply cooking oil. When reusing, use alcohol to remove oil and disinfect each part.

6. The oil inside the reducer should be kept at the no oil mark. After two to five months of normal operation, the waste oil should be drained and replaced with new oil. Add cooking oil to the oil cup on the hopper three times per shift, and add an appropriate amount of engine oil to other gear sprocket points.

What are the details that everyone needs to pay attention to when using a fully automatic water pill machine? Have you learned everything? I also hope this article can be helpful to everyone.

6. The oil inside the reducer should be kept at the no oil mark. After two to five months of normal operation, the waste oil should be drained and replaced with new oil. Add cooking oil to the oil cup on the hopper three times per shift, and add an appropriate amount of engine oil to other gear sprocket points.

What are the details that everyone needs to pay attention to when using a fully automatic water pill machine? Have you learned everything? I also hope this article can be helpful to everyone.