How to install explosion-proof control box

The explosion-proof protection level is IP65. Suitable for flammable and explosive environments, such as coal mining, chemical, petroleum, power and other industries. It has the characteristics of high safety factor, strong operational function, and stable performance.

Installation specifications for explosion-proof control box:

There are two installation methods for explosion-proof control boxes: wall mounted and floor mounted

Before installing the explosion-proof control box, it is necessary to check whether the technical data on the nameplate matches the actual usage situation, check whether all fasteners are loose, and tighten them if they are loose. The internal and external grounding of the junction box must be good and reliable;

The selection of explosion-proof control box and explosion-proof electrical control box is very important, and the explosion-proof mark of the explosion-proof electrical control box should be compatible with the explosion-proof of hazardous gases on site. When installing the explosion-proof electrical control box, the rubber sealing ring inside the cable entry device should not be discarded, and the compression nut should be tightened. All screws on the box should be tightened without any defects;

Before installing the explosion-proof control box, it is necessary to check whether the technical data on the nameplate matches the actual usage situation, check whether all fasteners are loose, and tighten them if they are loose. The internal and external grounding of the junction box must be good and reliable;

5. The installation of explosion-proof control box wiring is a part of the assembly of the electrical control cabinet. To do a good job in installation, it is necessary to understand the basic installation information and knowledge in order to better install. If you want to learn more about the assembly of explosion-proof control boxes, you are welcome to follow explosion-proof control box manufacturers. Here, we not only provide you with new industry trends, but also offer explosion-proof electrical appliances and other equipment;

6. The cross-sectional area of the small wiring of the explosion-proof control box circuit cannot be less than 1.5 square meters, and the current circuit cannot be less than 2.5 square meters. If such standards cannot be met, the circuit must not be able to withstand large currents, reduce its service life, and cannot meet its usage needs. Therefore, when selecting the circuit, it is necessary to choose according to the specifications to avoid affecting the normal operation of the explosion-proof control cabinet.