The semi-automatic capsule filling machine is a new type of pharmaceutical packaging machinery with a novel structure and beautiful appearance. This machine adopts electrical and pneumatic joint control, equipped with electronic automatic counting device and speed control device, which can respectively complete the actions of capsule positioning, separation, filling, locking, etc., replacing manual filling, reducing labor intensity, improving production efficiency, accurate filling dosage, and meeting pharmaceutical hygiene requirements. This machine is sensitive in action, accurate in filling dosage, easy to operate, and suitable for filling various domestic or imported capsules. It is currently an economical and practical equipment for filling capsule drugs in the pharmaceutical industry.

Below, the editor will briefly introduce the common faults and solutions of semi-automatic capsule filling machines, as follows:

1. The mold cannot be reset in the track, and the pressure spring at the back of the guide rail is stuck or the capsule is deformed and stuck. Reinstall the spring or top rod, and push the push rod down to clamp the capsule.

2. The capsule shells are arranged in the workbench, with the mouth raised or lowered, and the height of the misalignment plate and guide rail are adjusted.

3. Loosen the screw, tighten the screw.

4. Too many inverted capsule shells (exceeding), improper adjustment of the vibrator, due to adjusting the appropriate voltage or capsule shell size not meeting specifications, qualified capsule shells should be selected.

5. The guide plate in the mold is worn, which affects the low fitting rate of the capsule. Replace the mold with a new one or loosen the positioning on both sides. Tighten the positioning nails. If the capsule is deformed or damp, replace the capsule shell.

6. The vibration is not ideal, adjust the voltage.

7. The capsule shell is stuck on the table and cannot fall. Replace the capsule shell or adjust the position of the misalignment plate and the table hole.