Aluminum fluoride flow measurement device

XF-6609A alumina powder loose density tester

Aluminum fluoride flow measurement device1、 According to complianceGB∕T 6609.25-200425Technical specification for chemical analysis methods and determination of physical properties of alumina - Determination of bulk density. Chemical analysis methods and physical property determination methods for alumina Part

Determination of Partial Loose Density

2、 Technical parameters of alumina bulk density tester:1. Funnel: Inner diameter of mouth100mm, taper angle60oInside the discharge port6mm

.2. Measuring cylinder: approximately200ml1The ratio of inner diameter to inner height6：Outer diameter of the base

70mm

3. Material: Stainless steel material

Aluminum fluoride flow measurement deviceFunnel: made of stainless steel material, with an outer diameter at the upper opening of the funnel138.5mm,inside diameter123mm

,The outlet diameter is3.95mm～4.0mm,Total height190.5mm

Wear resistant stainless steel.Upper mouth taper:60°Taper of discharge port15°

.

Aluminum fluoride loose density measuring device1. Funnel: Upper inlet diameter100mm, taper angle60°, neck length8mmInside the lower discharge port6mm

.2. Cylindrical container: with a capacity of approximately200mL1The ratio of internal meridian to internal height6：

The inner bottom is flat.

3. Circular funnel holder: Install a fixed funnel ring holder on a sturdy base with pillars, and fix the ring holder to the pillars with long screws, which can be freely adjusted. Install the funnel on the predetermined level above the cylindrical container.Buy alumina powder loose density tester, aluminum fluoride flowability measuring device, Xiamen Xiongfa Instrument Co., Ltd【 http://www.1718cheng.com 】,Welcome to inquire: Contact: Kang Yulin Mobile187-5927-8268 QQ：754-625-297Fixed line: