BLS-118L wet desulfurization and dust collector

brief introduction
Based on the problems existing in the use of multiple water dust collectors, our factory leaders and technical departments have conducted repeated investigations, devoted themselves to researching and absorbing the advantages of multiple water dust collectors, and adopted many innovative technologies to successfully develop a set of water dust collectors that can adapt to various sintering methods, various harsh conditions, and overcome difficulties that other water dust collectors cannot overcome, namely the BLS-II-8L double cone tower low resistance and high efficiencyScrubberThe biggest feature of the KFX-I fast mud water separator system is:
1. Double cone tower dust removal is adopted to prevent mud and water from contacting the cylinder wall, thus preventing blockage caused by dust adhesion.
2. The sprinkler head is installed outside the dust area to prevent dust from coming into contact with the nozzle, solving the problem of water blocking the nozzle and affecting the suction effect.
3. The twin towers are directly installed on the two chimneys of the vertical kiln, avoiding the resistance caused by the winding path of flue gas. Therefore, the equipment resistance is very low, and there is no need for induced air or reverse smoke phenomenon.
4. By using a large amount of water for dust removal, the circulating water is accelerated, resulting in lower water temperature. This can solve the problems of pipeline structure, reduced water evaporation, and poor dust removal effect.
5. All use recycled water and never discharge or waste water resources into the kiln.
6. The sewage discharged after dust collection can be quickly separated from the mud and water through the mud water separator. The separated mud is continuously discharged to the twin shaft mixer in the form of Congee paste, and no special equipment for sludge discharge is required. The recovered mud is 100% recycled, and there is no secondary pollution problem caused by discharging to the ground.
7. The operating cost of the equipment is low, with a power consumption of only 9KW. The working principle of the cyclone dust collector
8. Less investment, with a lower investment of about 100000 yuan per unit compared to similar products. Therefore, this technology is largely superior to existing forms of water dust collectors and ensures dust removal efficiency. The dust emission concentration of open flame kilns does not exceed 150mg/m3, and that of dark flame kilns does not exceed 100mg/m3.
Technical performance
1. The processing capacity is 30000-60000m3/h;
2. Allow dust concentration within 50g/m3;
3. Dust removal efficiency ≥ 99.6%; Dust emission concentration is lower than the national standard for Class II areas;
4. Wastewater treatment capacity of 20m3/h;
5. Water consumption of 0.2m3/h;
6. The power consumption is 9KW, and when induced draft is required, it is 31KW;
7. Discharge mud with a water content of 50%;
8. After treatment, more than 50% of sulfur dioxide can be removed;
9. 100% utilization rate of recycled water;
10. 100% utilization rate of recycled materials;
11. Equipment investment ranges from 400000 to 500000 yuan per set.