Welcome Customer !

Membership

Help

Beijing Beifen Sanpu Instrument Co., Ltd
Custom manufacturer

Main Products:

pharmamach>Products
Product Categories

Beijing Beifen Sanpu Instrument Co., Ltd

  • E-mail

  • Phone

  • Address

    No. 43, Xibanbidian Village, Huilongguan Town, Changping District, Beijing

Contact Now

HY-5 (A) rotary speed controlled oscillator (shaker)

NegotiableUpdate on 02/10
Model
Nature of the Manufacturer
Producers
Product Category
Place of Origin
Overview
HY-5 (A) rotary speed controlled oscillator (shaker)
Product Details

1、 Introduction:

HY-5(A)Rotary speed controlled oscillator (shaker)It is an ideal tool that is essential for laboratories in various colleges and universities, environmental protection, health, epidemic prevention, petroleum, metallurgy, chemical, grain and other units. It greatly improves the work efficiency of laboratory personnel and can be used for solution analysis in containers such as test tubes, separating funnels, and triangular flasks,HY-5 (A) rotary speed controlled oscillator (shaker)Solved the problem of movement during the operation of other oscillators, with no noise, and added a timing device for the convenience of laboratory personnel.

IIHY-5(A)Rotary speed controlled oscillator (shaker)Technical parameters:

1. Oscillation frequency: 0-280 times/minute (stepless speed regulation), with A: for speed measurement
2. Working dimensions: 45 × 33cm External dimensions: 45 × 35 × 23 cm (universal fixture)
3. Vibration amplitude: 20mm
4. Continuous work: 8 hours
5. Power single-phase AC: 220V ± 10V 50HZ
6. Timing range: 0-120 minutes
7. Motor power: 80W
8. Working method: Spinning

IIIHY-5(A)Rotary speed controlled oscillator (shaker)usage method:

When using this instrument, first connect the power supply, then place the volumetric flask that needs to oscillate the solution into the spring fixture, cover the mouth with a rubber stopper, turn on the timer, select the time you need to control or turn it to the normally open position, and then turn on the power switch to start working. When working, please choose the oscillation speed that you are satisfied with. The speed control switch is controlled by a timer, and it should start at a low speed when starting up.

4HY-5(A)Rotary speed controlled oscillator (shaker)matters needing attention:

To ensure safety, please connect the ground wire (i.e. three pin plug) when using
When not working, the power should be turned off and cut off to prevent accidents.
3. The instrument should be kept clean and dry, and it is strictly prohibited to use a metal hammer to strike it.