Ordinary abrasive bulk density tester/manufacturer of abrasive bulk density tester

Ordinary abrasive bulk density testerDetailed introduction:

Abrasive packing densityThe mass of abrasive per unit volume in air, measured in grams per cubic centimeter, in the case of natural accumulation of granular abrasives; Same product as the BDMP-1 bulk density tester in the standard

1、 Made according to the requirements of GB-T3603-83 for measuring the bulk density of ordinary abrasives, suitable for measuring the bulk density of abrasives with particle sizes of 8-240 for corundum and silicon carbide.

IIOrdinary abrasive bulk density testertechnical requirement

1. Funnel material: brass or stainless steel; Cone height: 82 millimeters; Cone angle: 60~63 °;

2. Inner diameter of funnel neck: 12.7 ± 0.05 millimeters; Funnel neck length: 12.70.05 millimeters.

3. Process requirements: Smooth surface without any processing marks.

4. The funnel locking device is a rubber ball with a diameter of 35 millimeters. Fix two springs at the lower end of the funnel neck. The distance from the lower end of the funnel neck to the measuring cylinder mouth is 115 ± 2 millimeters.

5. Material of measuring cylinder: brass; Inner diameter: 39 ± 0.1 millimeters; Internal depth: 83.7 ± 0.1 millimeters; Volume: Approximately 100 centimeters 3

6. Scraper plate material: brass

7. Choose a balance: Weigh 500g, accurate to 0.1 grams

8. Ordinary abrasive bulk density testerto configure:

Rack: 1 set; Funnel: 1 piece; Measuring cup; 1 piece of brass material (Φ 31mm, 25ml);; 1 stainless steel overflow tray; 1 brush; instructions; warranty card; certificate.