How to use the electric capping machine and adjust some of its structures:

　　A、 Adjustment of the upper arm of an electric capping machine when rolling bottles of different specifications

The electric cap rolling machine can be used to roll 5-500ml bottle caps. When using any specification of bottle, simply place the bottle on the tray, hold the crossbar with one hand, and loosen the nut on the left side of the crossbar with the other hand to lower or raise the crossbar until the cap head is about 20mm from the bottle cap. Then tighten the nut and use the randomly provided hex wrench to tightly press the support ring against the crossbar and lock it. When tightening, pay attention to aligning the capping head with the bottle cap position.

　　B、 Adjustment of V-shaped support block for electric capping machine

Place the bottle into the lower V-shaped support, loosen the two screws on the support block, move the bottle and the lower V-shaped block together until the capping head is aligned with the bottle cap, and then tighten the two screws on the V-shaped block.

　　C、Adjustment of electric capping machine capping head

The electric capping machine is equipped with multiple capping heads, which can be selected according to the size of different bottle caps. Before formal use, you can try using a bottle.

1. The lid is not tightly rolled, you can unscrew the locking nut of the lid head in a counterclockwise direction to remove the upper lid head, and then tighten the upper fixing nut.

2. The lid is rolled too tightly and there is a phenomenon of unscrewing the bottle cap. You can unscrew the locking nut of the upper rolling cover head and screw it clockwise into the upper rolling cover head, then lock the upper fixing nut.

　　D、Specific operation method of electric capping machine

1. Place the bottle filled with liquid and capped onto the lower tray, lean against the V-shaped support block, hold the bottle with one hand, and tighten the handle downwards with the other hand. At this point, the tray lifts the bottle upwards until the cap is tightly pressed against the capping head.

2. After the bottle cap is tightly pressed against the capping head, the three continuously rotating capping blades rotate several times to tighten the bottle cap. The motor must run clockwise.

3. Push the handle forward to make the rolled lid return to its original position with the tray. The entire operation process is completed. Repeat the above operation for each bottle cap rolled in the future.