Electric capping machine

1、 Adjustment of the upper arm when rolling bottles of different specifications

This machine can be used to roll bottle caps of 5-500ml. When using any of the bottle sizes, simply place the bottle on the lifting plate (2), hold the crossbar (8) with one hand, and loosen the nut (9) on the left side of the crossbar with the other hand to lower or raise the crossbar until the cap head is about 20mm from the bottle cap. Tighten the nut and then use a randomly provided hex wrench to tightly press the support ring against the crossbar and lock the support ring (7). When tightening, pay attention to aligning the capping head with the bottle cap position.

2、 Adjustment of V-shaped support block

Place the bottle into the lower V-shaped support, loosen the two screws on the support block, move the bottle and the lower V-shaped block together until the capping head is aligned with the bottle cap, and then tighten the two screws on the V-shaped block.

3、 Specific operating methods

1. Place the bottle filled with liquid and capped on the lower tray, lean against the V-shaped support block, hold the bottle with one hand, and tighten the handle downwards with the other hand. At this point, the tray lifts the bottle upwards until the cap is tightly pressed against the capping head.

2. After the bottle cap is tightly pressed against the capping head, the three continuously rotating capping blades rotate several times to tighten the bottle cap. The motor must run clockwise.

3. Push the handle forward to make the rolled lid return to its original position with the tray. The entire operation process is completed. Repeat the above operation for each bottle cap rolled in the future.

4、 Adjustment of the capping head

This machine is equipped with multiple capping heads, which can be selected according to the size of different bottle caps. Before formal use, you can try using a bottle.

1. If the lid is not tightly rolled, you can unscrew the locking nut of the lid head and unscrew the upper lid head (5) counterclockwise, then tighten the upper fixing nut.

2. The lid is rolled too tightly and there is a phenomenon of rotary cutting of the bottle cap. You can unscrew the locking nut of the upper rolling cover head and screw it clockwise into the upper rolling cover head, then lock the upper fixing nut.

3. If the lower edge of the bottle cap cannot be tightened, the eccentricity of the three rolling blades can be adjusted appropriately according to the actual situation. If the bottle is too tight and crushed, the eccentricity of the three rolling blades can be adjusted appropriately.

5、 Partial bottle cap adjustment reference value

• Main technical parameters：

1. Usage specifications: Glass bottle sealing for 6-33mm oral liquid bottles, penicillin bottles, large and small infusion bottles, etc；
   2Applicable specifications:3ml-500ml
   3Production capacity:5-30Bottle/minute
   4Motor power: 220V, 50Hz,180w
   5Dimensions: 700 × 400 × 600 mm
   6Machine weight:40kg