Xilin bottle capping machine electric capping machine

Operation, adjustment, and precautions: Describe according to the machine's operating procedures. 1. After handling the bottles, do not mistakenly put broken or cracked bottles into the hopper. The bottles are pushed into the hopper by the slope of the hopper and their own weight, and then sent into the bottle feeding screw through the bottle dropping track. In order to ensure that the bottles can enter the bottle feeding screw smoothly, the width of the bottle dropping track should be appropriate to prevent the track from being too wide and the bottles from falling horizontally, and the track from being too tight and blocking the bottles, which may cause subsequent bottle shortages and bottle tipping, resulting in the bottles being rolled at the connection between the bottle dropping track and the bottle feeding screw. The bottles are smoothly and regularly sent into the rotary table bottle groove by the bottle feeding screw. It is necessary to adjust the synchronization between the bottle feeding screw and the rotary table to ensure that the bottles enter the rotary table groove as a whole. The main engine transmission should avoid the connection between the bottle feeding screw and the rotary table. Improper bottle rolling is mainly caused by adjusting the feeding position of the bottle screw, the time difference between the speed and the connection position of the turntable, You can first loosen the bottle screw transmission gear and adjust it before fixing the gear screw. When the machine is about to end running, there are not many bottles in the bottle dropping track of the feeding hopper, which reduces the push of bottle feeding. At this time, manual assistance is required to safely feed the remaining bottles in the bottle dropping track into the bottle feeding screw, so that the equipment can operate normally and avoid bottle rolling faults. 2. Infusion needle. In order to prevent the foam of the liquid medicine from overflowing the bottle mouth, the filling liquid is filled in two times. GenerallyoneAbout two-thirds of the amount needs to be measured for the second infusion, and the second infusion serves to replenish the liquid. The up and down movement of the needle is coordinated with the turntable drive and the action of the infusion components. When the main drive turntable just stops rotating, the needle descends (the height of the needle can be adjusted by the needle head frame), and the infusion begins. When the turntable has not yet started, the needle rises and the liquid stops. If the up and down movement of the needle is not coordinated with the turntable action, do not move the main engine action, but adjust the front and rear positions of the cam under the needle frame. After the action is coordinated, all fastening screws must be locked to prevent inaccurate action.