1. The sensor of the weighing scale is a very sensitive measuring device and must be handled with care. Avoid vibration, compression, or objects falling on the weighing platform (weighing conveyor belt) Up there. Do not place tools on the weighing platform.
2. During the transportation of the weighing scale, the weighing conveyor belt must be fixed in its original position with screws and nuts.
3. The products to be weighed should enter the weighing scale regularly, that is, the spacing between the products should be as equal as possible, which is a prerequisite for reliable weighing.
4. Please keep the photoelectric switch clean! Due to dust, stains, or moisture condensation on optical components, it may cause malfunctions. If necessary, gently wipe these components with a soft cloth or cotton cloth.
8. Please keep the weighing belt conveyor of the weighing scale clean, as stains or residue left by the product may cause malfunctions. You can use compressed air to blow away dirt or wipe with a damp soft cloth.
6. If the weighing scale is equipped with a belt conveyor, please check the conveyor regularly. The conveyor belt should not come into contact with any protective devices or transition plates (smooth plates between adjacent conveyor belts), as this can cause additional wear and vibration, which may have a negative impact on accuracy. If protective devices are installed, please check if they are in good condition and installed in the correct position. Replace the worn belt as quickly as possible.
7. If the weighing scale is equipped with a chain conveyor belt, please regularly check the protective devices to ensure that they are in good condition and installed in the correct position.
8. When installing a remover with an independent base or a remover with an independent bracket (column), please ensure that the bottom foot screws or bottom plate are firmly fixed to the ground. This can reduce disruptive vibrations.
9. Maintain inventory of spare parts, especially those that are prone to wear and tear, in order to shorten downtime caused by damage to spare parts.