Zirconia centrifugal spray dryerIts working principle is that the air enters the air distributor at the top of the centrifugal spray dryer through the filter and heater, and the hot air enters the dryer evenly in a spiral shape. The material liquid is pumped from the material liquid tank to the centrifugal atomizer at the top of the dryer through a filter, causing the material liquid to spray into extremely small mist droplets. The material liquid and hot air come into contact in parallel, and the moisture evaporates rapidly, drying into finished products in a very short time. The finished products are discharged from the bottom of the drying tower and the cyclone separator, and the exhaust gas is discharged by the fan.

Zirconia centrifugal spray dryerComponents: feeding system, heating system, drying system, receiving system, exhaust system, electrical control system.

Zirconia centrifugal spray dryerProcess parameters:

1. Material: Zirconia

2. Initial moisture content:~60%

3. Final moisture content:~1%

4. Water evaporation rate: 5Kg/h

5. Heating method: electric heating;

6. Inlet air temperature: about 300 ℃

7. Air outlet temperature: 110-130 ℃

8. Recycling method: primary cyclone+bag filter

9. Equipment material: 304 stainless steel at the material contact point

10. Installation: Indoor

11. Power supply: 380V 50HZ