Process flow of pharmaceutical liquid preparation system

　　The process flow of pharmaceutical liquid preparation system can be roughly summarized as the following steps:

　　Preparation of raw materials and formulation design

Store the required raw materials (solid reagents, liquid reagents, pure water, etc.) in dedicated containers as needed, and design formulas according to specific requirements.

　　Enter formula and set parameters:

Enter the formula into the programming system to determine the volume and pH value of the required solution.

　　Start the system and begin dispensing:

The program is easy to write and intelligent, with simple operation. If the system is not used for a long time, it will automatically clean. According to the formula, the system calculates the required amount of solution and adds solid or liquid reagents along with purified water to the mixing and stirring tank.

　　Monitoring and adjustment:

Use sensors to detect solubility, temperature sensors to monitor temperature, and pH meters to measure acidity and alkalinity. Adjust the volume, pH value, temperature and other parameters of the solution as needed.

　　Filtering and packaging:

Filter the solution as needed to remove impurities and particles. Then transfer the solution to the prepared container and attach an automatically printed label.

　　Recording and Cleaning:

Record the key parameters and results during the configuration process, and clean the system to prepare for the next use.