The linear sealing machine is a filling and sealing host in liquid production lines, mainly used for filling, capping, capping (rolling), and sealing 30-500ml glass or plastic bottles.

Sharing the use, maintenance, and installation of a linear sealing machine:

1. Before driving, you must first use the joystick to rotate the machine and check if there is any abnormality in its rotation. Only after confirming that it is normal can you start driving.

2. Because this filling machine is an automated machine, it is required to have uniform sizes for easy to pull bottles, bottle pads, and bottle caps.

3. When adjusting the machine, tools should be used appropriately. It is strictly prohibited to use excessive tools or force to disassemble parts to avoid damaging the components or affecting the performance of the machine.

4. After adjusting the machine, be sure to tighten any loose screws and use a shaking handle to rotate the machine to check if its movement meets the requirements before starting the car.

5. The machine must be kept clean, and it is strictly prohibited to have oil stains, chemicals, or glass shards on the machine to avoid damage to the machine. Therefore, it is necessary to:

⑴ During the production process, the machine should promptly remove liquid medicine or glass debris.

Before handing over the shift, each part of the machine surface should be cleaned once, and clean lubricating oil should be added to each activity department.

⑶ It should be thoroughly cleaned once a week, especially in areas that are not easily accessible during normal use, or blown clean with compressed air.