The swing pellet machine uses mechanical transmission to make the drum oscillate back and forth, extruding wet powdered materials from the sieve into pellets, and can also crush and granulate clumped dry materials. This machine is suitable for pellet processing in industries such as pharmaceuticals, chemicals, and food.

The common problems and solutions of the swing pellet machine are as follows:

1. Uneven particles

Possible reasons: Damaged screen mesh, uneven particle size of raw materials, improper amplitude/frequency setting of granulator.

Solution: Replace the damaged screen mesh, select raw materials with uniform particle size, and adjust the amplitude/frequency parameters. ‌

2. Machine vibration

Possible reason: The ground is uneven.

Solution: Move the device to a flat surface for operation. ‌

3. The drum does not rotate after being powered on

Possible cause: The drum is stuck by foreign objects.

Solution: Clean the foreign objects inside the drum after shutting down. ‌

4. Rough surface of particles

Possible reason: The moisture content of the raw materials is too high.

Solution: Reduce the moisture content of raw materials. ‌

5. Excessive powder content in particles

Possible reason: Insufficient moisture content in the raw materials.

Solution: Increase the moisture content of raw materials. ‌

6. Bearing damage

Possible reasons: excessive operation or running too fast.

Solution: Replace damaged bearings and pay attention to equipment maintenance. ‌

7. Abnormal noise during processing

Possible reasons: Hard foreign objects falling into the machine cavity or damaged bearings.

Solution: Stop the machine to remove foreign objects or replace the bearings. ‌