1、 Cleaning locations: workshop dry granulation room, tool cleaning room.
2、 Cleaning agents: 0.03% detergent water, drinking water, and purified water.
3、 Conditions, frequency, and methods for implementing cleaning:
1. Wipe off the dust on the surface of the equipment with a special cleaning cloth at any time. If there is any dirt, dip it in 0.03% detergent water and wipe the surface of the equipment. After visually inspecting that there is no dirt, use a clean equipment cleaning cloth to wipe it clean.
2. Clean up the accumulated dust and dust around the equipment in a timely manner every day.
3. Clean the medicine powder adsorbed on the filter bag of the vacuum cleaner after work every day, and dispose of the medicine powder in the powder bucket of the vacuum cleaner as required. Check again according to the above content and do a good job one by one.
4. When changing varieties or specifications, the equipment should be cleared.
(1) Unscrew the feeding funnel bolt, press the up button, remove the funnel, open the particle box door, and remove the stainless steel screen and drum.
(2) Remove the vacuum tube, vacuum port, filter bag and other accessories of the vacuum cleaner.
(3) Turn off the power and clean the inner and outer surfaces of the equipment with drinking water. Rinse the vacuum tube, vacuum port, and main unit with drinking water.
(4) Rinse the filter bag repeatedly with drinking water.
(5) When encountering difficult to clean parts, use a nylon brush dipped in laundry detergent and brush while rinsing until clean.
(6) After the above accessories are visually free of dirt, oil stains, and residue from the previous product, rinse, scrub, or rinse once with drinking water, and then rinse, scrub, or rinse once with purified water.
(7) Waiting for equipmentthoroughlyAfter cleaning, use a device cleaning cloth to dry the main components and inner walls of the equipment, without any water droplets.
(8) The cleaned filter bag is placed flat in a dedicated tool storage rack Once there is no water dripping out, return it to the dust collector and run it empty until the filter bag is dry.
4、 Cleaning effect evaluation: After treatment, there is no visible dirt, oil stains, or residue from the previous product inside and outside the equipment.
5、 Storage of cleaning tools: After using the cleaning tools according to the cleaning operation procedures for production tools and containers in the clean area, they should be stored in the cleaning tool storage room.
6、 Attention:
1. During cleaning, it is necessary to prevent water from directly entering the electrical parts.
2. After cleaning, ensure that the pressure wheel is dry. If it does not dry, use a hair dryer to blow it dry.
3. When cleaning the filter bag, do not use a brush to scrub it.
4. When cleaning the straw, tie the nylon brush with a long nylon rope and pull it from one end of the straw to the other, repeatedly scrubbing until it is clean.