How to correctly use, maintain and repair liquid filling machines
Date: 2018-10-11Read: 14
Firstly, let's take a look at how to use, maintain, and install:
1. Because this filling machine is an automated machine, the sizes of easy to pull bottles, bottle pads, and bottle caps are required to be uniform.
2. Before driving, you must first use the joystick to rotate the machine and check if there is any abnormality in its rotation. Only after confirming that it is normal can you start driving.
3. When adjusting the machine, tools should be used appropriately. It is strictly prohibited to use excessive tools or force to disassemble parts to avoid damaging the components or affecting the performance of the machine.
4. After adjusting the machine, be sure to tighten any loose screws and use a shaking handle to rotate the machine to check if its movement meets the requirements before starting the car.
5. The machine must be kept clean, and it is strictly prohibited to have oil stains, chemicals, or glass shards on the machine to avoid damage to the machine. Therefore, it is necessary to:
⑴ During the production process, the machine should promptly remove liquid medicine or glass debris.
Before handing over the shift, each part of the machine surface should be cleaned once, and clean lubricating oil should be added to each activity department.
⑶ It should be thoroughly cleaned once a week, especially in areas that are not easily accessible during normal use, or blown clean with compressed air.
Disinfection and rinsing
1. Loosen the upper and lower fastening screws, disassemble the dispensing system for overall disinfection, or disassemble and clean separately.
2. Place the inlet pipe in the cleaning solution and turn it on for cleaning.
3. The 500ml model may have errors in actual filling, so use a graduated cylinder to measure accurately before formal filling.
4. The filling machine uses needle tubes, standard 5ml or 10ml syringes for Type 10, 20ml glass filling machine for Type 20, and 100ml glass filling machine for Type 100.
Installation precautions
1. After unpacking the machine, first check whether the random technical information is complete and whether the machine is damaged during transportation, in order to solve it in a timely manner.
2. Install and adjust the feeding and discharging components according to the outline diagram in this manual.
3. Apply new lubricating oil to each lubrication point.
4. Rotate the machine with a joystick to check if the machine is running in the correct direction (counterclockwise facing the motor spindle), and the machine must be grounded for protection.