The two-dimensional motion mixer is mainly composed of a material cylinder, an upper frame (shaker), a lower frame, a rotating mechanism, a swinging mechanism, and an electrical device. The rotating mechanism adopts a cycloidal pinwheel reducer, located inside the upper frame. During operation, the reducer drives the drive shaft through sprockets and chains, and then rotates the material drum through the drive wheel. The swing mechanism is located inside the lower frame and is equipped with a worm gear reducer or a cycloidal pinwheel reducer. When working, the electric motor is transmitted to the reducer through a pulley or sprocket, and then the upper frame is shaken through a connecting rod assembly to make the material cylinder swing at a certain angle.

When installing and using a two-dimensional motion mixer, the following aspects should be noted:

1. The installation of the equipment does not require anchor bolts, but it needs to be placed on a solid and flat ground.

2. There is a grounding device inside the electrical control box of the equipment, and the user must connect it to the on-site protective grounding system.

3. The end of the material barrel with a discharge guide plate should be located on the front of the equipment (front of the electrical control box).

4. The guide plate has both left and right rotation, so the material barrel cannot be freely rotated forward or backward. The guide plate is a left-handed material cylinder, which rotates counterclockwise for mixing and clockwise for discharging. The direction of mixing and discharging in a right-handed drum with a guide plate is the opposite. Therefore, the motor wiring should pay attention to the phase sequence to ensure the correct direction of mixing in the drum.

5. Before using the equipment, a no-load test should be conducted to check if it is operating normally.

6. Operate the equipment according to the text instructions on the electrical control box. The stop buttons for "swing" and "discharge" are used simultaneously as a trigger. Before starting or changing the direction of the material drum, the stop button must be pressed first to avoid excessive starting current.

7. When closing the lid of the material cylinder, tighten the star shaped handle proportionally to achieve even sealing.

8. When the equipment is running, it is strictly prohibited to stand in the direction where the material cylinder swings.