1、 Usage:
1. Place the ultrafine grinder on a sturdy platform and turn on the power.
2. According to the characteristics of the crushed material, select the corresponding cutting tools for assembly and install them on the rotor.
3. Open the feeding hopper and evenly add the material to be crushed into the hopper mouth.
5. By adjusting the speed controller and selecting the appropriate speed, the desired crushing effect can be achieved. Generally speaking, the higher the speed, the finer the crushing effect.
6. During the operation of the equipment, lubricating fluid can be added in a timely manner to reduce equipment friction and wear.
7. After the material is crushed, turn off the equipment and wait for it to stop running before opening the safety door for sampling.
2、 Attention:
1. Before using the ultrafine grinder, be sure to carefully read and understand these instructions.
4. During the feeding process, the material to be crushed should be evenly distributed around the rotor cutting tool to avoid uneven crushing caused by oversized or undersized materials.
5. During the feeding process, the stability of the hydraulic pressure in the disc should be maintained to avoid equipment blockage or material splashing caused by too low or too high flow rate.
6. Before starting the device, check for any debris or obstacles around the device and ensure that it is not disturbed.
7. During the operation of the equipment, the wear of the cutting tools should be regularly checked, and if there is any damage, they should be replaced in a timely manner.
8. During the operation, the equipment should be kept clean and the dust and impurities inside and outside the equipment should be cleaned at all times.
9. When using lubricants, appropriate lubricants should be selected and added according to the prescribed dosage and method.
10. When cleaning equipment, the power should be cut off first, and a clean cloth or brush should be used to clean the equipment. Do not use water to directly clean the equipment.