Electric heating pure steam generator is a device that uses deionized water as raw material water and steam heating to produce pure steam. It has a reasonable structure, simple operation, high thermal efficiency, and low energy consumption. It is an ideal equipment for sterilization and disinfection in hospitals, pharmaceuticals, electronics, food, and beverage industries, and is a cGMP compliant equipment in the pharmaceutical industry.

The precautions for using an electric heating pure steam generator include the following aspects:

1. Safe operation: When using an electric heating steam generator, safety operating procedures should be followed to ensure the normal operation of the equipment and the safety of personnel.

2. Regular maintenance: To ensure the normal operation and extend the service life of the equipment, regular maintenance and upkeep should be carried out.

3. Reasonable use: Use the electric heating steam generator reasonably according to actual needs to avoid energy waste caused by excessive use.

4. Installation and operation:

Ensure that the electric heating steam generator is correctly installed and powered on. Operate according to the instructions of the device, set the required working parameters and steam output.

During the operation, closely monitor the operating status of the equipment to ensure its stability and safety. Regularly inspect various components of the equipment, such as heating elements, sensors, etc.

Before starting the equipment daily, open the steam safety valve and drain valve to discharge the water and dirt inside the furnace.

Ensure that key components such as the electrical control box and water pump motor are kept dry and clean to avoid moisture interference.

5. Pollution discharge and water treatment:

After the end of each day's work, wait for the pressure to drop to 0.05Mpa before carrying out the discharge operation. Be careful and cautious when discharging to prevent burns.

Two daily time checks of water treatment equipment are required to ensure consistency with the actual time.

If the time for adding salt to the salt box has been set, the salt addition operation must be strictly carried out according to the specified time.