The dust-free particle crushing unit is widely used for crushing and processing materials such as grass, flowers, stems, seeds, fruits, etc. The processed materials have uniform particles and low powder content.
Key points for daily maintenance and upkeep of dust-free particle crushing unit:
1、 Daily cleaning management
1. Equipment surface cleaning
Use a dust-free cloth or nano sponge to wipe the body daily to avoid dust accumulation and affect heat dissipation
The internal parts of the crushing chamber need to be disassembled and cleaned to prevent residual materials from hardening and blocking
2. Key parts treatment
The screen mesh needs to be regularly removed and cleaned with a soft brush to remove holes. Water containing materials should be cleaned immediately after processing to prevent blockage
Check the smoothness of the discharge outlet daily and use compressed air to blow away any accumulated material
2、 Mechanical component maintenance
1. Lubrication and maintenance
The main shaft bearings are lubricated with specialized grease every month, and the oil nozzle is kept clean to prevent impurities from entering
Check the wear of transmission components such as worm gears and worm gears every quarter and replenish lubricating oil
2. Inspection of vulnerable parts
Check the blade wear of the hammer/tool every 200 working hours, and replace the passivation in a timely manner
The tension of the V-belt is adjusted monthly to prevent slipping or excessive tension from damaging the bearings
3、 Electrical system maintenance
Check the wire joints for looseness every week, and ensure that the dust cover of the control panel is sealed properly
The motor cooling fan should be cleaned of accumulated dust every quarter, and any abnormal capacitance should be professionally inspected and replaced
4、 Environmental and storage requirements
The equipment should be placed in a dry and clean environment to avoid corrosion from acidic and alkaline gases
When not in use for a long time, apply anti rust oil and cover the entire machine with a dust cover
5、 Operating standards
Check for abnormal vibration or noise during idle operation before starting
The material input needs to be uniform, and overloading operation will accelerate component wear
• It is recommended to establish a maintenance record table to track the time of each maintenance and the replacement of parts. For complex faults, professional maintenance personnel should be contacted for handling.