Sugar coating machineIt is mainly used for coating and polishing formed tablets, pills, and granules in the pharmaceutical industry. It can also be applied to candy mechanism or coating in the food industry. The coated and polished sugar coated tablets have a bright surface, can prevent oxidation, moisture or volatilization, and can cover unpleasant flavors, making drugs easy to identify and easing the dissolution effect in the human gastrointestinal tract. This unit is easy to operate, easy to maintain, and cost-effective, making it an ideal equipment for coating in the pharmaceutical industry.

Below, the editor will briefly introduce the installation and usage instructions of the sugar coating machine, as follows:

1. Connect the power supply. Attention: The phase and neutral wires cannot be connected incorrectly.

2. Connect the gas source to the air pipe joint on the lower side of the machine body through a Φ 8PU tube.

3. Add coating solution to the liquid cylinder.

4. Turn on the power switch and turn on the power at this time.

5. Adjust the host speed according to the instructions for using the host speed controller.

6. Turn on the air inlet adjustment switch, and the air inlet fan will start working.

7. Adjust the temperature controller to the temperature value you need. If the actual temperature is lower than the set value, the heater power will be turned on and the heater will start heating. If the actual temperature is higher than the set value, the heater power is disconnected and the heater stops heating.

8. Turn on the spray gun switch, and the spray gun will start working. Please refer to the spray gun manual for instructions on how to use the spray gun.

After adjusting the above functions appropriately, the air compressor can be started with an air pressure of about 4-6kg/cm3.