The sugar coating machine is mainly used in the pharmaceutical industry for coating and polishing formed tablets, pills, and granules. It can also be applied to the candy mechanism or coating in the food industry. The coated and polished sugar coated tablets have a bright surface, can prevent oxidation, moisture, or volatilization, and can cover unpleasant odors, making drugs easy to identify and easing the dissolution effect in the human gastrointestinal tract. This unit is easy to operate, easy to maintain, and cost-effective, making it an ideal equipment for coating in the pharmaceutical industry.

Below, the editor will briefly introduce the daily maintenance and operation precautions of the sugar coating machine, as follows:

maintenance

1. The machine must be reliably grounded, and its grounding resistance should be ≤ 4 Ω.

2. To ensure the lubrication conditions of the worm gear transmission in the gearbox, the temperature of the gearbox during operation should not exceed 50 ℃.

3. Do not dismantle electrical appliances and belt protective covers at will.

4. The sealing ring at the end of the worm shaft should be regularly inspected and replaced, generally not exceeding six months.

5. The lubricating oil inside the gearbox should be replaced regularly as required.

6. If the sugar coated pot is not used for a long time, it should be cleaned thoroughly, and the copper pot should also be coated with oil on its surface to prevent the oxidation or moisture of the copper material in the pot from producing toxic copper compounds.

Operation precautions

1. Before operation, it is necessary to carefully check whether the fasteners of each part of the machine are loose.

2. Start the main motor and let the machine run idle for 2 minutes to determine if there is *.

3. Clean the inside and outside of the sugar coated pot

4. After adding materials, the main motor button should be pressed first, and then the blower button should be pressed according to the crystallization situation of the sugar. At the same time, the electric heating wire switch should be turned on.