Precautions for installation of three piece quick release ball valve:

1. Remove the protective covers on both sides of the flange end and rinse and clean with the valve open.

2. Before installation, the entire machine should be tested according to the specified signal (electric or pneumatic) to prevent vibration from affecting performance during transportation. Only after passing the test can it be installed online (wiring should follow the electric actuator circuit diagram).

3. Before connecting to the pipeline, it is necessary to flush and remove any remaining impurities in the pipeline (which may damage the valve seat and ball).

4. During installation, please do not use the actuator part of the valve as a lifting point to avoid damaging the actuator and accessories.

5. This type of valve should be installed in the horizontal or vertical direction of the pipeline.

6. The pipeline near the installation point should not have any low hanging or external force bearing phenomenon. Pipe supports or supports can be used to eliminate the deviation of the pipeline.

7. After connecting to the pipeline, please cross tighten the flange connection bolts with the specified torque.