The swing pellet machine is mainly composed of the main body, pellet manufacturing device, gearbox, screen clamp tube, motor frame and other parts. The screen adopts metal wire mesh, which is easy to install and disassemble, and the tightness can be adjusted. The parts of the machine that come into contact with the material are made of stainless steel. The principle is to use mechanical transmission to make the rotating screen shake back and forth, extruding the material from the screen into particles, and crushing the dry material into particles. This device is suitable for industries such as medicine, food, and chemical engineering, mainly used to develop wet powder or block shaped dry materials into the required particles.
The usage method of the swing pellet machine mainly includes the following steps:
Check the equipment: Before use, first check whether the equipment is normal, including whether the compression ratio of the ring mold matches the raw materials produced, the smoothness of the inner hole of the ring mold, and whether it is out of roundness.
Adjust parameters: Adjust the gap between the pelletizer ring mold and the pressure roller as needed to ensure appropriate spacing and avoid increased friction caused by too small spacing or poor discharge caused by too large spacing.
Preparation of raw materials: Ensure that the moisture content of the raw materials is controlled within an appropriate range. Usually, the moisture content before tempering should be 12% -13%, and after tempering, it should be maintained at around 14% to avoid mold blockage and slippage.
Operating equipment: After starting the equipment, pay attention to the distribution of materials to ensure that they are evenly distributed in the pelletizer ring mold and avoid uneven discharge caused by one-sided distribution.
Maintenance equipment: Regularly check the operating status of the equipment to ensure that bearings and other components are working properly, and avoid production reduction caused by equipment failure.
Swing pellet machineMaintenance and upkeep:
Regularly inspect the wear of the ring mold and pressure roller, and repair or replace them if necessary.
Keep the equipment clean and avoid dust accumulation.
Regularly lubricate key components of equipment to ensure smooth operation