HZ series electronic water processor

HZ-100 electronic water processor

HZ series electronic water processorMain Features

1. It does not change the chemical properties of water and has no side effects on the human body.

2. The device can extend the service life of servo equipment.

3. The device is small in size, easy to install, and can be used without human supervision.

4. After passing through the device, water can be turned into magnetized water and has a certain inhibitory and killing effect on bacteria in the water.

5. The descaling effect is obvious. This device is installed in the water circulation system. For the original scale thickness below 2mm, it can gradually loosen and fall off after about 30 days. The treated scale is granular and can be discharged with the sewage pipeline without blocking the pipeline system,. After the old scale falls off, no new scale will be produced within a certain range.

Equipment selection

1. According to the selection of water treatment capacity, the diameter of the water processor should generally be equal to the diameter of the water pipe. If it does not match, a larger equipment should be selected.

2. The hardness of the water treated by this equipment is less than 800mg/L (calculated as CoCO3); Special requirements can be customized.

3. This product is prohibited from being used on steam boilers or pipe rack boilers.

4. L-type can be installed horizontally, vertically, or diagonally without paying attention to the direction of the inlet and outlet.

5. Scale prevention rate:>98%, scale removal rate>98%, sterilization and algae removal rate>97%, pipeline corrosion rate reduced by>95%.

6. Service life: Over 10 years.

Key points for installation of electronic water treatment instruments

The device has been debugged before leaving the factory and can be run directly by the user during use. When the operating parameters of the equipment cannot meet the user's requirements, the user can adjust the parameters according to the actual working conditions and choose manual or automatic control methods accordingly for operation.

*When running, the following steps should be followed:

Check if the filter is in normal working condition:

Check if the connections of the filter are secure;

Check that the filter electrical control box is dry.

When the power is turned on and the green power indicator light is on, it indicates that the electronic control part of the filter is in normal working condition and the equipment can be put into trial operation.

Note: When plugging in the power supply, attention should be paid to keeping hands dry. At the same time, during the operation of the filter, the electronic control part should be kept dry, and no water should enter the interior of the electronic control.

Characteristics of Electronic Water Treatment Instruments

1. Small size, easy to install.

2. Can adapt to high hardness water quality.

3. High output frequency and good processing effect.

4. The host is equipped with a reserved digital communication interface for long-distance digital communication, enabling overall control and monitoring of the system. 、

5. The built-in potentiometer can adjust the output power at any time, making it more adaptable to on-site changes

HZ series electronic water processor