1、 Preparation before startup:
1. When starting up, the clutch must be disengaged and the operating handle must be in the "off" position. After the no-load starting motor runs normally, the handle should be turned to the "on" position to close the clutch and start the mixer to operate.
2. Observe the movement position of the material strip, operate the clutch to place the feeding port in the ideal feeding position, disengage the clutch, cut off the power, release the feeding port clamp, remove the bottle cap for feeding, and the feeding amount should not exceed the rated valuelimited editionNot exceeding 2/3 of the material bucket.
3. When using vacuum feeding, a dedicated feeding port cover plate is used, which has two dedicated interfaces. The feeding interface is connected to the material in the raw material cylinder through a suction pipe, and the vacuum interface is connected to the quick interface on the lower side of the vacuum valve through a connecting pipe. The vacuum pump is turned on and the vacuum valve is opened to evenly suck the material into the mixer hopper.
4. After adding the ingredients, cover the bottle cap and tighten the clamp. When using vacuum feeding, tighten the sealing caps for the suction interface and vacuum tube interface to start mixing.
5. Press the fan start button and check if the fan direction is correct and if there are any abnormal sounds during rotation.
2、 Start up and run:
1. Adjust the time cut-off device according to the process requirements.
2. Strictly follow the procedures specified in section 1.1 to start up and mix.
3. The mixer will automatically stop at the set time. If the discharge port position is not ideal, you can operate it again according to the program specified in 1.1, manually operate the clutch to open and close, adjust the discharge port to the optimal position, cut off the power, and then proceed with the discharge operation.
4. Open the butterfly valve at the discharge port to discharge the material.
5. When discharging, the discharge speed should be controlled to control dust and material loss.
3、 Attention:
1. It is strictly prohibited to enter the mixing drum movement area during equipment operation.
2. If any abnormal situation occurs during the operation of the equipment, the inspection should be stopped and the maintenance team should be notified.
4. After production is completed, do a good job of clearing the equipment site.