The complete set of ultra-high temperature instantaneous sterilizer is composed of plate heat exchanger, balance tank, beverage pump, hot water device (including steam water mixer, hot water pump, steam regulating valve, etc. The feeding and discharging of this equipment are both equipped with three-way valves, and the flow rate can be adjusted as needed, ensuring reliable use.

Working principle of ultra-high temperature instantaneous sterilization machine:

Generally, materials are preheated by being pumped into the hot and cold material heat exchange device of the sterilization machine by a centrifugal pump, and then quickly heated to the sterilization temperature through a high-temperature bucket filled with high pressure, and maintained for about 3 seconds before and after this. Microorganisms and enzymes in the material are quickly killed. After the material is discharged from the high-temperature barrel, it is cooled by heat exchange with the cold material, usually at a temperature below 65 ℃. If the temperature needs to be increased in the next process, it can be achieved by adjusting the angle type shut-off valve or circulation, etc. Otherwise, the discharge temperature can be reduced by connecting cooling water. The discharge is controlled by a throttle valve, which can keep the boiling point of the material above the maximum temperature while maintaining a certain pressure. During normal production, adjust this valve to generate back pressure control flow by overcoming spring pressure with the driving force of the pump. When cleaning and sterilizing the machine, it should be fully opened. The circulating storage tank can be used to prepare acid-base solutions and effectively clean the scale on the inner wall of the coil. Due to the simultaneous use of stainless steel three-way plugs, the flow rate can be appropriately adjusted.