Desktop ampoule automatic sealing machine

desktopAmpoule automatic sealing machineThis machine is a new type of all-in-one machine, and the auxiliary gas pump pipe has been pre plugged in. When in use, simply connect the gas or liquefied petroleum gas, adjust the gas and auxiliary gas switches, and obtain a uniform and concentrated flame. When heating the ampoule, the circular ampoule placement platform can be slowly rotated to evenly heat the bottleneck. When softening, use tweezers to pull the upper end of the ampoule bottleneck upwards and break it, and the lower part of the ampoule bottleneck can be smoothly melted and sealed.

ZPRF1/20 desktopAmpoule automatic sealing machineInstructions for use

1. Connect the gas pipeline properly. (Interface for needle type regulating valve in the lower right corner of the mixed three-way valve behind the device)

2. Plug in the power cord. (Upper right corner socket at the back of the device)

3. Turn on the power switch (located in the upper right corner of the front of the device)

4. Slowly open the gas needle valve until the lamp head is lit.

5. Slowly open the auxiliary gas needle valve (located at the bottom left corner behind the equipment) until both lamp heads emit slender blue flames, and it can start working (the thinner the flames, the better)

6. Place the ampoules on the tray and do not immediately put them into the flame. First, check if the flame is at the center point of the tray and if it is at the desired sealing height (simply loosen a knob on the bracket to choose freely, and then tighten it)

7. Place the ampoule filled with the medicine solution back into the center of the tray and flame. Slowly and evenly rotate the bottle with your left hand, and when it turns red, use tweezers with your right hand to pull off the upper part.

8. After the work is completed, the auxiliary gas valve must be turned off first, and then the gas valve must be turned off.

ZPRF1/20Desktop ampoule automatic sealing machinePrecautions for use

1. The gas cylinder and gas generation chamber must be at least 6 meters away from the working position.

2. When igniting, do not place any part of your body in front of the flame gun nozzle. When igniting the lighter, it should be located on the side of the flame gun to avoid burning your hands. When igniting, it is necessary to first close the auxiliary gas valve, and slowly open the gas valve while igniting. Adjust the appropriateness of the flame only after it has been lit.

3. The needle type regulating valve on the gas pipe and the mixing tee must be connected properly, and there must be no leakage to avoid accidents.

4. When using, attention should be paid to opening the gas needle valve and the auxiliary gas needle valve slowly and evenly, not too fast, to avoid accidents.

5. When sealing ampoules, it is important to slowly rotate the bottle until it softens. Then, use tweezers to cut the upper end and seal the bottom of the bottle.

6. This machine cannot be directly rinsed with water to avoid mechanical damage.

Technical Specifications:

1. Applicable specifications: 1-20ml

2. Production: 1500-1800 pieces/hour

3. Voltage: 220V

4. Power: 500W

5. Auxiliary gas pressure: ≥ 0.04KPa

6. Gas pressure: ≥ 0.4KPa

7. Net weight: 45kg

8. Packing volume: 1000 × 600 × 600mm